on 03-20-2008 3:21 PM
Hi,
I activated 2LIS_11_VAHDR and performed Set up for it. I got the records extracted in RSA3. So I created an Infopackage for the Init load. Later, I created a Sales order in VA01 (R/3), got the records being added to the Table VBAK. After I went to transaction LBWE (application 11: SD Sales BW), where the update mode was "QUEUED Delta", I clicked on "Job Control" and scheduled for immediate run.
To test the delta, again I checked in RSA3 (for 2LIS_11_VAHDR) by putting appropriate ERDAT range. I got 0 records!!
Did I miss any steps to get the Delta records?
I have gone through the following links (including Roberto's Web log) below but could find useful for this scenario.
/people/sap.user72/blog/2004/12/16/logistic-cockpit-delta-mechanism--episode-one-v3-update-the-145serializer146
/people/sap.user72/blog/2004/12/23/logistic-cockpit-delta-mechanism--episode-two-v3-update-when-some-problems-can-occur
/people/sap.user72/blog/2005/01/19/logistic-cockpit-delta-mechanism--episode-three-the-new-update-methods
/people/sap.user72/blog/2005/02/14/logistic-cockpit--when-you-need-more--first-option-enhance-it
/people/sap.user72/blog/2005/04/19/logistic-cockpit-a-new-deal-overshadowed-by-the-old-fashioned-lis
Hello,
Check the Tcode LBWQ - qRFC outbound Queue or SMQ1 (qRFC Outbound Monitor) and and see if there is any entry for your datasource.
Also check RSA3 without any selection
Thanks
Chandran
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
I created another record (1 record) in the R/3. When I looked into LBWQ for the queue, it showed 1 entry. I scheduled for an immediate update using 'Queued Delta'. The LUW count in the RSA7 delta queue in R/3 incremented by 1 ( from 2 to 3). When I looked for the details for that particular DataSouce (2LIS_11_VAHDR) in the Delta Queue (RSA7), I found no entry. I do not know what do I do now.
Try looking in RSA7 and see if there are transactions posted there. If so, maybe you did not use the right parameters in RSA3. Make sure you select Update Mode = D and you select the right Target system.
Hope this helps.
BTW, leave the ERDAT selection field blank.
Edited by: Geo on Mar 20, 2008 11:37 AM
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
66 | |
8 | |
7 | |
6 | |
6 | |
6 | |
5 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.