on 07-10-2023 8:25 AM
Hello Experts,
Every time I try to deploy a new I-Flow, it gets stuck in the "Starting" state. And it was like that for several hours (until I undeployed it). Did I forget something during setup? Or is it a problem on the SAPs side?
P.S. I´m trying it with a fresh Trial account.
Thanks & Regards
Artiom
Hi,
It seems its a common issue on Trial account.
I suggest that you Go to Monitor -> integrations & Apis -> View Integration Content
choose your artifact and Refresh.
I hope that helps.
Best regards.
Abdul
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Artiom,
I had the same issue and solved it by saving the integration flow as a version instead of just saving it. I think it's because it saves as a Draft.
Hope this solves your problem!
Regards,
José Melo
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Artiom,
Probably some issue with the trial account. You can try to enable trial account in different region and check if the issue still persists.
Regards,
Priyanka
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi artiom.goldanski ,
From screenshots, I believe, because you are deploying an initial flow without making any changes to it, the flow is not deployed. Can you add some flow steps, such as a content modifier, sender channel, and so on, and then try to deploy it?
Kind regards, Vijay
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
83 | |
11 | |
10 | |
8 | |
7 | |
7 | |
6 | |
6 | |
5 | |
5 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.