Gateway parameters
Introduction: The gateway is installed within an instance by the dispatcher and reads its parameters from the profile file located in the profile directory in the SAP directory tree.
In addition of RFC Quota, I will discuss Gateway parameters, some very important Profile parameters for R/3, which effect lot to do the optimum config of R/3 stacks. As the optimum configuration of system for a high RFC load is significant.
For that we had
- General/Configuration parameters: for general setting and load balancing.
- Network parameters : for control the gateway behavior in networks
- Timeouts parameters: recognizes various timeouts
- Resource Management parameters : for managing gateway resources
- Security parameters: for security.
Details: The parameters listed below control the gateway resources. These include number of external connections, memory consumption, etc. These are Resource Management Parameters which effect lot in optimum configuration.
o Short description: max number of gateway clients
o This parameter specifies the maximum number of clients
connected at one time. Note that the gateway regards an SAP application server as one single client.
o Default value : 300
o Unit : Integer
o Short description: max number active connections
o This parameter specifies the maximum number of
simultaneous active connections.
o This includes both connections using LU6.2 and connections
using TCP/IP.
o Default value : 500
o Unit = Integer
o Short description: Percentage of overflow area
o Specifies the usage of the overflow area in % from which the
gateway slows down its clients, i.e., sends SYSN requests.
o Default value: 10
o Unit: Percent
o Short description: size of overflow area
o This parameter specifies the size of the local storage
area in which the SAP Gateway manages the received
requests.
o Default value : 10000000 ( 10MB)
o Unit: Bytes
o Short description: Max. number of requests put into
shared memory
o Specifie the maximum number of CPIC requests that
can be stored in the gateway in Shared Memory at a time.
o Unit : Integer
o Default value: 50
o Short description : number of requests put into shared
memory
o Specifies the maximum number of CPIC requests that can be
held simultaneously in shared memory for a CPIC connection.
The value of this parameter must not exceed the value of the
parameter gw/max_shm_req and is corrected by the
gateway if required.
o Unit : 1
Default value: 10
o Short description: number of stacks for CPI-C
communication
o This parameter specifies the number of CPIC requests that
can be on the stack for each CPIC connection.
o Unit : Integer
o Default value : 30
Practical: Execute the transaction SMGW
Here you can set gateway parameter values.
"
Want to digest more?
Memory Management of the SAP Gateway
Load Balancing for Registered Programs
Reference:
SAP ONLINE DOCUMENT.
Books:
Mastering SAP XI-Administration by Marcus and H Klein.
What next :
Tuning and Runtime category.