Skip to Content
Technical Articles
Author's profile photo Aslam Ansari

Post GM with own MVT type for GM initiated from EWM

Introduction:

In this blog post, we will discuss about how to post material documents with own defined MVT types for goods movements initiated from EWM system.

One simple example is Рonce we confirm put away WT in EWM then system posts 411 material document  in S4 core system for doing a transfer posting from ROD storage location to AFS storage location. Note: You can also work with only AFS storage location, There is no strict need to work with combination of ROD and AFS.

Solution Approach:

First thing that should come to your mind is- why system post transfer posting with MVT type 411?

Table /SCWM/TIMBWA will have answer to your question.

 

Now next question is – let say If I want to post transfer posting material document with 911 MVT type instead of 411 then how to setup this?

Ok- well, just create new MVT type 911 copying original MVT type 411.

Now go to below EWM customizing node to steer system to go to 911 from 411.

You are all done.

Now when you trigger any GM that was supposed to be posted with 411 in S4 core will be posted with MVT 911.

Just look at below example:

SAP standard setup-

Test with our new setup-

Conclusion: 

After following this blog post, you can setup the system to have your own defined MVT type for GM initiated from EWM system.

Thanks for your time to go through this blog post.

Please don’t hesitate to provide your feedback and suggestions to make this blog post even more productive and informative.

Thanks

Regards

ASLAM

Assigned Tags

      4 Comments
      You must be Logged on to comment or reply to a post.
      Author's profile photo Minh Tran Nguyen Ngoc
      Minh Tran Nguyen Ngoc

      Hi Aslam,

      Thank for your topic, but if the Logical System is blank like your picture, the system show error like this.

      An RFC destination could not be specified for the logical system DS4CLNT100

      Message no. B1550

      Is there any problems ?

      Thanks.

      Kent.

      Author's profile photo Aslam Ansari
      Aslam Ansari
      Blog Post Author

      Hello

      I am using embedded system , so I don't need to mention the logical system.

      If you have decentralized EWM, then you need to mention logical system of the connected ECC system (Hopefully it should be of ECC, not 100 % sure, you need to test).

      Regards

      ASLAM

       

      Author's profile photo Minh Tran Nguyen Ngoc
      Minh Tran Nguyen Ngoc

      Hi Aslam,

      Thank for your advise, I have found the missing configuration and update.

      Kent.

      Author's profile photo Aslam Ansari
      Aslam Ansari
      Blog Post Author

      Great that you have fixed it.