Skip to Content
Technical Articles
Author's profile photo Rashmi Joshi

SAP CPI Simulation Mode

Hi All,

Update :- Kamlesh Zanje  from SAP also published article on the same. Please look this article for more details on this topic.

https://blogs.sap.com/2020/04/13/integration-flow-simulation-in-sap-cloud-platform-integration/

 

New feature released by SAP which is used to Test multiple Iflow steps using the new Simulation Mode. This feature enables integration developers to test integration flow during development without need to deploy an integration flow.

Below are the steps on how to use this feature.

 

  1. Switch on the Simulation Mode ON
  2. Select the start and stop step to perform the simulation                                       Fig.(1) – Select Start Step                                       Fig.(2) – Select End Step
  3. Run Simulation 
  4. Select message icons to view the payload

 

Regards,

Rashmi

Assigned Tags

      6 Comments
      You must be Logged on to comment or reply to a post.
      Author's profile photo Fatih Pense
      Fatih Pense

      Hi Rashmi, thanks for sharing!

      It seems like we have published 3 blog posts at the same time. The last one is by SAP 🙂

      https://blogs.sap.com/2020/04/13/integration-flow-simulation-in-sap-cloud-platform-integration/

      Regards,
      Fatih

      Author's profile photo Jagadish Babu Parri
      Jagadish Babu Parri

      nice option

      Author's profile photo Jonathan Ma
      Jonathan Ma

      How come I don't see that simulation mode button?

      Author's profile photo Lucy Meng
      Lucy Meng

      Hello Jonathan, have you found the simulation in button edit mode? I have the same issue, not found the simulation button in my iflow.Thanks to let me know if you have solved the issue

      Author's profile photo Keerthana Jayathran
      Keerthana Jayathran

      Hi Lucy Meng ,

      There is no simulation mode button with 3.31.x/6.7.x release.You can set start and end points and run simulation.The points should be set by selecting the connector.

      Hope this helps.

      Regards,
      Keerthana

      Author's profile photo Christian Michael Cagaanan
      Christian Michael Cagaanan

      Hi,

      It seems there is a limit to 10 nodes only. Is there a way to simulate more than 10 nodes?