Skip to Content

Introduction:

The transaction code ES31 is used to update the rate category at the installation level. In this article we shall work out updating the rate category at the installation level through programming.

Steps through SAP transaction ES31:

ES31 Initial Screen

ES31 Init.JPG


Under Installation Time-dependent data section, provide new rate category and click ‘SAVE’.

RC screen.JPG


Steps through a program: Sample Code


DATA : wa_obj                      TYPE isu01_instln,

            wa_auto                     TYPE isu01_instln_auto,

            l_installation               TYPE anlage,

            l_new_rate_category TYPE tariftyp.

*—–Open the Installation in change mode—–*

          CALL FUNCTION ‘ISU_S_INSTLN_PROVIDE’

               EXPORTING

                    x_anlage                  = l_installation  “Pass Installation Number Here!

                    x_keydate                = ‘20160105’     “This is the Key Date

                    x_wmode                 = ‘2’                   “Open up the installation in change mode

               IMPORTING

                   y_obj                         = wa_obj

                   y_auto                       = wa_auto

               EXCEPTIONS

                    not_found                 = 1

                    invalid_keydate        = 2

                    foreign_lock             = 3

                    not_authorized         = 4

                    invalid_wmode         = 5

                   general_fault             = 6

                   OTHERS                   = 7.


             IF sy-subrc NE 0.

*————–Handle failures

                  RETURN.

             ELSE.

                  SORT wa_obj-eanlh BY bis DESCENDING.

                  READ TABLE wa_obj-eanlh INDEX 1

                             ASSIGNING FIELD-SYMBOL(<lfs_eanlh>).

                  <lfs_eanlh>-tariftyp = l_new_rate_category. “Pass the new rate category here!

             ENDIF.

*—–Instructions to save the changes—–*

wa_auto-contr-okcode                = ‘SAVE’.

wa_auto-contr-use-okcode         = ‘X’.

wa_obj-auto-contr-use-okcode   = ‘X’.

wa_obj-auto-contr-okcode          = ‘SAVE’.

*—–Provide the updated values and instructions for update—–*

          CALL FUNCTION ‘ISU_S_INSTLN_CHANGE’

               EXPORTING

                    x_anlage                 = l_installation

                    x_keydate               = ‘20160105’

                    x_prorate                = ‘X’

                    x_upd_online          = ‘X’

                    x_no_dialog            = ‘X’

                    x_auto                     = wa_auto

                    x_obj                       = wa_obj

               EXCEPTIONS

                    not_found                = 1

                    foreign_lock             = 2

                    not_authorized         = 3

                    cancelled                 = 4

                    input_error               = 5

                    general_fault            = 6

                    OTHERS                  = 7.

              

               IF sy-subrc NE 0.

*—————Handle failures

               ENDIF.

To report this post you need to login first.

Be the first to leave a comment

You must be Logged on to comment or reply to a post.

Leave a Reply