Skip to Content
Product Information
Author's profile photo sandeep praharaj

PP module and PM module Integration (For tracking the usage value of PRT’s)

This document explains integration between PP module and Plant Maintenance (PM) module

Overview: Integration between PP and PM modules happens during following scenarios…

A) During Capacity Planning for work centers

Already Document has been posted by Our expert Integration between PP module and PM module by Kkumar

B) For tracking the usage value of PRT’s

The below step should be followed for achieving the requirement.

Step 1Create PRT using T.code & Assign Measuring point – IE25/IE01



Step – 2

Create Measuring Point IK01


Step 3


Create a measuring point document with initial counter Reading


Step 4

Create the Maintenance plan and counter for the PRT and enter the data.

Creation of Maintenance plan for the PRT (T.code- IP41)

Step 5

Assign the PRT in the routing.

Click on PRT icon

Select the Equipment icon and assign the created PRT to the routing and save it.

Step 6 – Create the Production order for the material using T.code- CO01

Step 7:- Confirm the production order qty using T.code – CO11


Step 8 :- Check the Measurement document of the PRT. [ T.code- IK17 ]

Thanks & Regards

Sandeep Kumar Praharaj

Assigned Tags

      You must be Logged on to comment or reply to a post.
      Author's profile photo MAHENDRAN PARAMASIVAN


      Author's profile photo sandeep praharaj
      sandeep praharaj
      Blog Post Author

      Thanks Mahendran

      Author's profile photo Juan Pablo (JP) Veliz Montoya
      Juan Pablo (JP) Veliz Montoya

      Great post Sir,  Appreciate it.

      Author's profile photo sandeep praharaj
      sandeep praharaj
      Blog Post Author

      Thanks Juan

      Author's profile photo Former Member
      Former Member

      Hello every one,

      Its a very good post sandeep sir,good info.However,even when I have followed the above steps as they are given but unfortunately measuring document is not getting generated through production order confirmation.I have spent many hours looking for the solution or any link which i have missed out between these steps....Please help me out with this...Any one with any suggestion are most welcome.

      Author's profile photo sandeep praharaj
      sandeep praharaj
      Blog Post Author



      Have you followed all the steps correctly kindly cross check once again still facing issue than contact  any PM consultant avalaible to check the issue.




      Author's profile photo Dinesh kumar
      Dinesh kumar

      Good work Sandeep

      Author's profile photo Sanjay Chavan
      Sanjay Chavan

      Good. Value adding document. Sandeep

      Author's profile photo S@P PM
      S@P PM

      Can same functionality be used for Recepie and Process order . pls suggest

      Author's profile photo sandeep praharaj
      sandeep praharaj
      Blog Post Author

      Hi ,


      Yes it can be used.


      Thnaks & Regards



      Author's profile photo Namit Kumar
      Namit Kumar

      Thanks Sandeep for this blog.

      Author's profile photo Michael Vielsack
      Michael Vielsack

      After several days of trial, I would like to add one tiny, but very important information:

      Make sure that the PRT Control key Settings (IMG>Production>Production Control>Master Data>PRT>Define PRT Contorl Key)

      have the setting "confirmation" flagged !



      Author's profile photo Lee Khim Chua
      Lee Khim Chua

      Hi All

      I checked my routing screen (CA01/CA02) is missing with Counter area for measuring point. May I know how can I enable it?

      My production order confirmation could not auto-generate measuring document although I had setup as per above. The only missing is routing screen with Counter area.

      Can you help to advice?