Skip to Content

Requirement – To create SmartForm with signature to be embedded on Prints where Signature is stored on the Printer

Solution:

Setup Device Type and Print Control

  1. goto tcode SPAD
  2. Identify the Device type associated with your printer
    • Enter Output Device click Display
    • Goto -> Device Type
  3. start SPAD again with Full Administration
  4. goto device type tab
  5. Enter device type click display
  6. Create Print control Z* and Sequence code for Printer Signature

Setup and generate Printer Fonts

  1. Goto tcode se73
  2. Select Device type
  3. Click Print Controls
  4. Check if the created print control is visible, if not add it by opening in Change mode
  5. Once Print control is visible- Click Generate Font for the selected device type

Create SmartForm

  1. Create Smartform with a Window e.g. Signature
  2. Create a Flow Logic -> Command under this window
  3. Enter the Print Control Name

Post Transport

  1. Run Report – RSTXDELL
  2. Clear Cache using SPAD

To check if the Control sequence is printed or not

Check Spool output of this form in RAW OTF format (Extras-> OTF Display in Print Prview screen)

You should see the Print Control in the form that was created during device setup

To report this post you need to login first.

Be the first to leave a comment

You must be Logged on to comment or reply to a post.

Leave a Reply