In  previous blog (SAP AIF -Simple Inbound Scenario – Part-3),  we were updating the PA006 table, Here for Outbound case we will trigger a report (SAP ECC) which will capture the updated PERNR’s, totals No of records updated on particular date.

In outbound case  the destination / target structure is called as Raw Structure, Source Structure is called as SAP Data Structure.

Ambu.PNG

Steps –

  SAP  PI –                                                                       

       ESR

 

Create—

  •   Two  Data type
  •    Message type(ZDT_ADDRESS_RES)
    /wp-content/uploads/2015/08/1_770500.png

Two Service interface
(SO_AIF_ADD_RES)

  Category-Outbound

  Message type – ZDT_ADDRESS_RES

  (SI_AIF_ADD_RES) Category –Inbound

2.PNG

Message mapping – One to One

Operation Mapping —OM_ResSrcECC_PITgt

/wp-content/uploads/2015/08/3_770511.png

INTEGRATION DIRECTORY

Business System – BS_SAPECC

Business Component –BC_SAP_AIF

Register the Service Interface in Business Component.

/wp-content/uploads/2015/08/4_770512.png

Communication Channels–  File Receiver (BC_SAP_AIF)

/wp-content/uploads/2015/08/5_770591.png

  Configuration  Scenario

     •     Receiver Determination,

     •     Interface  determination

     •     Sender agreement

     •     Receiver agreement

For Outbound Service interface (SO_AIF_ADD_RES ) created in ESR (SAP PI) and a proxy structure for service interface is generated in SAP
ECC.

              SAP ECC

T-Code- SPROXY

  Generate and activate the proxy    /wp-content/uploads/2015/08/6_770625.png

  

  Go to Properties tab —/wp-content/uploads/2015/08/7_770639.png

We need to create a SAP Data Structure in SE11 .

SAP AIF customization will be covered in Part 2

To be continued:- Part 2

  SAP AIF- Simple Outbound Scenario Part-2

                                                          

To report this post you need to login first.

3 Comments

You must be Logged on to comment or reply to a post.

Leave a Reply