Skip to Content

This lesson will be another short and sweet one.  Who doesn’t like things to be straightforward.  ha ha ha  This is often another piece that doesn’t need to be touched, unless your FICO group gives you specific instructions to change it.  And if they do, it’s really easy 🙂

/wp-content/uploads/2013/05/blog_01_208739.png

Here’s where you locate it in configuration.

/wp-content/uploads/2013/05/blog_02_208741.png

You’ll notice again, this is by order type.  Now you can’t be plant specific in this screen, but typically, that isn’t a requirement I’ve run into.

Settlement rule Time:  You have a few options, and all this section does is determine when the settlement rule must exist in the service order.  Keep in mind, if you’re dealing with the in-house repair scenario, the settlement rule will be generated for you, so it won’t really matter what setting you choose.

/wp-content/uploads/2013/05/blog_03_208742.png

Distribution Rule Sub-Order:  This is the setting to apply if you are using Sub-Service Orders (IW36).  You can define how the settlement rule should be determined.

/wp-content/uploads/2013/05/blog_04_208743.png

That’s it.  Nice and easy. 

If you’re interested in great tips and tricks on SAP service management, variant configuration or ABAP Development, check out my blog at: http://paperstreetenterprises.com/blog/

There is also a link to some SAP Easy Buttons =)

Thanks for reading,

Mike

CTO – JaveLLin Solutions, LLC

To report this post you need to login first.

Be the first to leave a comment

You must be Logged on to comment or reply to a post.

Leave a Reply