1 Datasource in ECC System to 2 Seperate Systems (BW1 and BW2)

[naresh_babu3]

Scenario:  1 Data source in ECC system to 2 Separate System (BW1 and BW2)

Solution:   Two Initialization  can be done for single Data source from two BW systems

Whenever u initialize the Data source at the BW1 and BW2 side, then in the R/3 the delta queue will be created with the following columns :

in the above case u have 2 system : BW1 and BW2 in RSA7 for the same Datasource (Shown in Figure).

DATASOURCE                 BW SYSTEM             NO. OF RECORDS

==========                    ==========              =============

2LIS_03_BF                      ABC1(BW1)                   225

2LIS_03_BF                      ABCD(BW2)                   50

Points to be remember:

1. There will be two Initialization for one Datasource from respective Target system's.

2. There will be two delta's for one Datasource.

3.  Infopakage is target based, so even though delta is running daily for one datasource, again you can do the Initialization.

Regards,

Naresh