For Object XABBELEGNR, number range interval does not exist OMJ6

[former_member292201]

Dear Sir,

I would like to post an error which i am getting.

Screen shot is attached for your reference.

I have already checked OMJ6, OMC1 and SNRO. all are maintained but still the error is coming. I need your help in this regards.

OMJ6:

If any details is required I shall definitely provide.

Thanks & regards,

Koushik

[former_member213836 · Accepted solution]

Hi Koushik,

Please send the complete screenshot of error after selecting the question mark

Among other things did you Activate GR/GI Slip Number range check for the plant?

Upon checking this I am getting following standard warning message. So not sure if you can make use of Material Slip/Delivery Note as an alternative per recommendation. If I were you I will go with what is suggested here.

Regards,

Niranjan

[former_member292201 · Accepted solution]

Dear Sir,

As per the requirement I am sending the screen shot details for your kind perusal.

Thanks & regards,

Koushik Goswamy

[former_member213836 · Accepted solution]

Hi Koushik,

Here is what I Did

1. Create New Number range Grouping  Code - 51 and assign external No range Interval 01.

2. Assign New Grouping Code 51 to Plant Sloc and movement type. It was working

Note: This config was created by SAP for Italy where this is a legal requirement and its up to you to decide whether to use it for other countries or not.

Regards,

Niranjan

[former_member213836 · Accepted solution]

Hi,

I dont see storage location in your screenshot. You will get missing no range error if Storage Location is blank.

regards,

Niranjan